5.3
Installing the rear clamping arm
4
Insert torsion spring (4).
N
Hook pin (arrow) into torsion spring (4).
N
Slide on clamping arm (3).
N
Screw on nut (2).
N
Install E-clip (1).
N
Turn clamping arm (3) by the hexagon
N
counterclockwise as far as it will go and hold.
Tighten nut (2).
N
Install the rear V belt, @ 4.3.
N
Install "starter cover with rewind starter", @ 4.3.
N
Fit guard, @ 4.3.
N
5.4
Removing the front clamping arm
Prepare for repair, @ 3.1
N
Remove guard, @ 4.2.
N
Remove "starter cover with rewind starter", @ 4.2.
N
Remove the rear V belt, @ 4.2.
N
Remove the front V belt, @ 4.4.
N
Remove the middle belt pulley, @ 6.2.
N
Undo nut (10).
N
Remove screws (11).
N
Remove the holding-down clamp (12).
N
8
3
N
N
N
N
N
13
13
Push tension rod (13) upward and hold it there.
Push the brake lever (9) gently downward. The
tension rod (13) will detach from the brake lever (9).
Remove E–clip (5).
Undo nut (6).
8
Pull off clamping arm (7) and remove torsion
spring (8).
9
7
TS 440