Assembling And Installing The Brake Lever - Stihl TS 440 Service Manual

Remove E-clips (4).
N
Pull off brake lever (3) and lever (5).
N
Remove lever (5) from brake lever (3).
N
9.3

Assembling and installing the brake lever

Clean lever (5), brake lever (3) and installation site.
N
10
Grease pins (9, 10) including the surfaces in the area
N
around the brake lever (3).
3
Insert lever (5) into brake lever (3).
N
Push brake lever (3) and lever (5) onto the pins on the
N
connector.
Fit the E-clips (4).
N
Grease area around the lever (arrows). Total quantity
N
of grease: 10 g (0.4 oz.).
TS 440
9
5
1
8
Push brake lever (3) upward and hold it there.
N
Hook in the tension rod (7).
N
Push brake lever (3) downward.
N
Hook tension spring (1) into the lever (5) and push it
N
over the pin (arrow) with the aid of the assembly
tube (8) 1117 890 0900.
Install brake band, @ 8.3.
N
Install connector, @ 7.3.
N
Install rear clamping arm, @ 5.3.
N
Install rear ribbed V-belt, @ 4.3.
N
Install "starter cover with rewind starter", @ 4.3.
N
Fit guard, @ 4.3.
N
3
5
7
17