Installing The Control Panel - Stihl TS 440 Service Manual

Pull plug connection (15) and wires (arrows) out of
N
the guides and disconnect.
Remove screws (9).
N
Remove shroud (10).
N
11
Pull the wires of the control panel (11) out of the
N
guides.
Release retaining tabs (arrows) and push out control
N
panel (11).
16.3

Installing the control panel

11
Insert control panel (11) and press in. The retaining
N
tabs engage.
Push wires into the guides (arrows) with the aid of the
N
wiring tool and pass plug (16) through the opening.
TS 440
15
16
10
Attach throttle rod to rib of air guide shroud.
N
Place shroud (10) in position, passing plug (16)
N
through the opening (arrow).
Insert switch (13).
N
Insert screw (12) and tighten.
N
Push the short circuit and ground wires into the
N
guides (arrows) with the aid of the wiring tool.
Hook throttle rod (14) onto throttle trigger.
N
Insert screws (9) and tighten.
N
Install switch shaft (6).
N
Insert handle molding (5).
N
Insert screw (4) and tighten.
N
Fit grommet (3).
N
Fit cap (2), insert screw (1) and tighten.
N
16
12
13
14
39