Add Ipsi Translations To Multivantage Software - Avaya S8700 Installing Manual

The subnet address must match the most significant 3 octets (the first 3 groups of digits
in the subnet address) of the Server IP address filled in on the control network entry from
the filled-out job aid entitled Pre-Installation Network Planning Forms—S8700 Media
Server.
An Asterisk (*) to the right of the Subnet Address field means that although a subnet
address is displayed, it is not the correct one; the Avaya MultiVantage call processing
software does not have the subnet information. After verifying the displayed
information, submit this form with or without changes to update the Avaya MultiVantage
software with the correct subnet information.
!
CAUTION:
If the information displayed in the Primary and/or Secondary Subnet Address fields is not
correct it must be changed on the media servers. Use the Configure Server entry on the
Web Interface application to change the media server configuration. Then return here to
perform this step.
3 Set the Switch Identifier: field to the switch ID letter (A thru J; A is the default
setting).
Set the IPSI Control of Port Networks: field to enabled.
4
5 Press to effect the change.
Enter

Add IPSI Translations to MultiVantage Software

NOTE:
The information you provide differs, depending whether the IPSIs get static addresses or
they are assigned automatically through DHCP.
Type add ipserver-interface PNnumber and press
1
information.
When using static addressing, in the Host: field, type in the IP address for the IPSI in
2
the port network listed in the Location: field.
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
Primary IPSI
------------
Location: 8A02
Host: 192.168.18.40
DHCP ID: ipsi-A08a
Verify that all the other fields are populated.
October 2002
Customizing the Active Media Server
to add the IPSI circuit pack
Enter
Socket Encryption? y
Enable QoS? y
QoS Parameters
--------------
Call Control 802.1p: 6
Call Control DiffServ: 46
55