Connect The P333T-Pwr Switch - Avaya S8700 Installing Manual

Connect the P333T-PWR switch

Power up—AC input
Insert the power cord into the power connector (BUPS or AC Power Supply) on the rear
1
of the unit. See ''Connectors on the P333T-PWR switch'' on page
Connectors on the P333T-PWR switch
1
BUPS
INPUT
Figure notes
1 BUPS connector
Insert the other end of the power cord into a nonswitched electrical outlet or the
2
connector on the BUPS.
The unit powers up and performs a self-test procedure. The LEDs flash at regular
intervals after the self-test procedure is completed successfully.
Power up—DC input (optional)
The P333T-PWR switch can operate on the AC input only. However, you may wish to use the
optional DC input for the following:
Backup for the power over Ethernet ports
•
To provide more than 200 watts for the power over Ethernet ports
•
NOTE:
Please refer to the P333T-PWR switch User's Guide for more information.
Connect the Cables
Connect IP telephones, PCs, servers, routers, workstations, and hubs.
Connect the Ethernet connection cable (not supplied) to a 10/100 megabits per second
1
port on the front panel of the Avaya P333T-PWR switch.
NOTE:
Use standard RJ45 connections and a CAT5 cable for 100 megabits per second operation.
Connect the other end of the cable to the Ethernet port of the PC, server, router,
2
workstation, IP telephone, switch, or hub.
NOTE:
Use a crossover cable when connecting the Avaya P333T-PWR switch to a switch or hub.
Installing and Wiring Telephone Power Supplies
INPUT
Vin 44-57V Amax 15A
2 AC connector
October 2002
187.
2
scdlp333 KLC 082002
187