Power Up And Test The Power Supply; Wire The 1146B2 Power Distribution Unit - Avaya S8700 Installing Manual

Media server with media gateway
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

8
Power-up the 1145B2 as described on the label on the side of the unit.

Power Up and Test the Power Supply

The following table describes the meaning of the power supply LEDs when lit.
LED Color
Meaning
Green
Power Supply is providing power
Yellow
Battery is charging
Red
Power Supply is on battery reserve
1
Connect the AC power cord to the power supply and route the cord to an appropriate AC
outlet using the clips provided on the unit.
NOTE:
A maximum of four power supplies can be powered from one dedicated 100–120 V, 50/60
Hz, 20-amp feeder or 200–240 V, 50/60 Hz, 10-amp feeder. Use only nonswitched outlets.
Plug the cord into the outlet. This powers up the power supply.
2
3
Check AC operation of the 1145B2 Power Supply by monitoring the LEDs:
PASS : Green and yellow LEDs at the front of the unit should be lit together. Green
means the power supply is providing power. Yellow means the battery is being charged.
After the battery reaches full charge (maximum of 20 hours), the yellow LED should go
out.
FAIL : If either green or yellow LED is not lit after powering up, check the connections.
Test the AC outlet. If power is available and the AC power cord and connections are
good, replace the power unit.
Disconnect the AC plug on the power supply, this activates the DC supply.
4
5
Check DC (battery back-up) operation of the 1145B2 Power Supply by monitoring the
LEDs:
PASS : The red and green LEDs should be lit together. Red means the power supply is
on battery back-up.
FAIL : If either green or red LED is not lit after disconnecting AC power, check the
connections. If the connections are good, replace the power unit or batteries.
Reconnect AC power to the power supply.
6

Wire the 1146B2 Power Distribution Unit

Wire endpoints to the 1146B2 while power from the 1145B2 is on. A red LED lights if its
associated circuit is connected to shorted wiring or to a shorted telephone.
Installing and Wiring Telephone Power Supplies
October 2002
181

Advertisement

Table of Contents
loading

This manual is also suitable for:

G600

Table of Contents