Avaya S8700 Installing Manual page 46

46
Configure the UPSs
NOTE:
These steps are specifically for the Powerware 9125 UPS equipped with a ConnectUPS
MX SNMP module. These steps use the default addresses and subnet masks for the S8700
Media Server for Multi-Connect Configuration. If other addresses are to be used they must
be substituted when performing these steps. Refer to the filled-out Job Aid entitled
Pre-Installation Network Planning Forms -- S8700 Media Server for the proper data.
Connect the services laptop computer (RS-232 serial port) to the DB-9 connector on the
1
back of the ConnectUPS MX module for UPS 1. Use a DB-9 to DB-9 serial cable
(supplied with the ConnectUPS
NOTE:
Avaya Terminal Emulation and HyperTerminal are supported terminal emulation
programs. Terranova is not supported.
Open a terminal emulation program (such as Avaya Terminal Emulation) on the services
2
laptop.
Administer the emulation program port settings:
3
Press
4
does not appear, press
5 Type BR 0 and press
Type IP 198.152.254.239 and press
6
7 Type NM 255.255.255.0 and press
Type GW 198.152.254.201 and press
8
NOTE:
If a Network Management System (NMS) is going to monitor the UPS units, coordinate
the assignment of community names with the LAN administrator (refer to the filled out
Job Aid entitled Pre-Installation Network Planning Forms -- S8700 Media Server). If an
NMS is not going to monitor the UPSs, set the community names to unique string values.
If supplied, enter the Get and Set community names with the following commands:
9
Type HS and press
10
• 9600 bps rate
• No parity
8 bits
•
• 1 stop bit
The Main Configuration screen appears. If the Main Configuration screen
Enter.
Enter
(Sets the BOOTP retry counter to zero.)
Enter.
Type CG <name> and press
•
community name. Type up to 16 alphanumeric characters for the name. The name
field is case sensitive and cannot contain blanks.)
• Type CS <name> and press
community name. Type up to 16 alphanumeric characters for the name. The name
field is case sensitive and cannot contain blanks.)
(Displays the Host Table)
Enter.
October 2002
TM
MX SNMP module.)
again.
. (Default IP Address for this UPS)
Enter
. (Default subnet mask for this UPS)
Enter
. (Default gateway for this UPS)
Enter
Where name is a unique string. (Enters the Get
Enter.
Where name is a unique string. (Enters the Set
Enter.
TM