Cabling 3 Media Gateways; Cabling 4 Media Gateways - Avaya S8700 Installing Manual

84
Cabling the G600 Media Gateways

Cabling 3 Media Gateways

1 Remove the bottom panel and fan assembly from media gateway C.
If not already removed, remove the fan assembly from media gateway B.
2
3 Remove the left TDM/LAN bus terminator from media gateway B, and install it at the
right end of the TDM/LAN bus in media gateway C.
4 Remove the nuts on the posts of the plates covering the bottom left TDM/LAN cable
routing slot of media gateway C and the top left TDM/LAN cable routing slot of media
gateway B. See
5 Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
both media gateways. Push the free end of the EMI Gasket back in place. See
''TDM/LAN bus cable routed through the media gateway'' on page
Install the lower terminator of the TDM/LAN bus cable on the left end of TDM/LAN bus
6
in media gateway B. Make sure the arrows on the back of the cable terminators point
upward.
7 Install the upper terminator of the TDM/LAN bus cable on the left end of the TDM/LAN
bus in media gateway C.
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the
8
ends of the routing slots are covered.
If finished, reinstall the fan assemblies and bottom panel. Otherwise continue cabling
9
media gateway D.

Cabling 4 Media Gateways

Remove the bottom panel and fan assembly from media gateway D.
1
2 If not already removed, remove the fan assembly from media gateway C.
Remove the right TDM/LAN bus terminator from media gateway C, and install it at the
3
left end of the TDM/LAN bus in media gateway D.
4 Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable
routing slot of media gateway D and the top right TDM/LAN cable routing slot of media
gateway C. See
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
5
both media gateways. Push the free end of the EMI Gasket back in place. See
''TDM/LAN bus cable routed through the media gateway'' on page
Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus
6
in media gateway C. Make sure the arrows on the back of the cable terminators point
upward.
7 Install the upper terminator of the TDM/LAN bus cable on the right end of the
TDM/LAN bus in media gateway D.
8 Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the
ends of the routing slots are covered.
Reinstall the fan assemblies and bottom panel on each media gateway.
9
''TDM/LAN bus cable routing slot plate removal'' on page 82
''TDM/LAN bus cable routing slot plate removal'' on page
October 2002
83.
82.
83.