Administer The Tn799Dp - Avaya S8700 Installing Manual

NOTE:
The TN799DP circuit packs are hot-swappable, so you do not need to power down the
media gateway to install them.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
Insert the TN799DP circuit packs into the port slots identified earlier.
1

Administer the TN799DP

Use Avaya Site Administration for the administration.
NOTE:
The customer or design team provides the actual names, IP addresses, subnet masks, and
gateway addresses. Refer to the filled-out Job Aid entitled Pre-Installation Network
Worksheet for them.
Log in as craft.
1
Type list configuration all and press
2
recognizes the TN799DP circuit packs.
Type change node-names and press
3
4 On page 2, type in the node names and IP addresses for each TN799DP C-LAN circuit
pack.
change node-names ip
Name
csr1clan1
sr1clan2
traf-clan
( 12 of 12 administered node-names were displayed )
Use 'list node-names' command to see all the administered node-names
Use 'change node-names ip xxx' to change a node-name 'xxx' or add a
node-name
5 Type display circuit-pack and press
Code column.
Type change ip-interfaces and press
6
to verify that the MultiVantage software
Enter
.
Enter
IP NODE NAMES
IP Address
192.168.1 .80
172.16 .19 .220
172.16 .19 .118
. . .
. . .
. . .
. . .
. Verify that the TN799DP shows up in the
Enter
.
Enter
October 2002
Connecting to the Customer's Network
Page 1 of
Name IP Address
.
.
.
.
.
.
.
115
1
. .
. .
. .
. .
. .
. .
. .