Avaya S8700 Installing Manual page 131

change ip-interfaces
Enable
Eth Pt Type Slot Code Sfx Node Name
y C-LAN 01C16 TN799
y MEDPRO 01E04 TN2302
y VAL 01C08 TN2501
n
n
n
n
n
n
n
n
n
n
n
n
Set the Enable Eth Pt field to y.
2
3 Set the Type field to VAL.
4 Type the circuit pack location in the Slot field (UUCSS).
If a TN2501AP circuit pack is not at this location when you submit the screen, the
software prompts you to enter a VAL circuit pack location.
In the Node Name field, enter the Node Name you entered with the change node-names
5
ip command.
If you press Help, a list of administered node names appears (including the name you
administered with the change node-names ip command), and you can select from the list.
Set the Subnet Mask field according to your network requirements.
6
Gateway address is usually the same as the TN2501AP circuit pack's IP address, usually
with the fourth octet changed. Be sure to set this address according to your network
requirements.
7 Press to save the changes.
Enter
Administer the data module
Type add data-module extension and press
1
The Data Module screen appears. Use this screen to administer the data module that is
associated with the TN2501AP ethernet port.
IP INTERFACES
Subnet Mask
C st12clan 255.255.0
st12prowler#1 255.255.0
VAL#1 255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
Enter
October 2002
Connecting to the Customer's Network
Page 1 of 6
Gateway Address Rgn
.0 172.22 .22 .254 1
.0 172.22 .22 .254 1
.0 172.22 .22 .254
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
.
131
Net