Setup: How To Make The Settings - GRAPHTEC GL900 Quick Start Manual

2. Setup: How to Make the Settings

Make the settings required for data capture. Here we will make only those settings that are
absolutely necessary. The other settings will be left as the default settings (the settings made
prior to shipment from the factory)
Basic Setup Menu Operation
The keys used on the menu screens are the
key. The current cursor position is displayed in blue. Use the
Points to
Remember !
If you press the ENTER key at the cursor position, a selection menu or a box for inputting
numeric values and so forth is displayed. If you press the QUIT key, the screen closes and
the settings are canceled.
lExamples of selection menu operations (AMP screen)
1. Use the
cursor to the Input parameter
opposite CH 1 and then press the
ENTER key.
(Note: Select "DC" for voltage measurement, and "Humidity" for humidity measurement.)
10
keys to move the 2.A selection menu is displayed
when the ENTER key is pressed.
Use the
"TEMP."
1. Press the MENU key to display the setup menu screen.
2. Select "1V" for the Range parameter for CH 1 and CH 2.
(1)Move the cursor to the Range parameter opposite CH 1 and select "1V".
(2)Make the same setting for CH2.
3. Select "Off" for all the other channels.
(1)Using the procedure described above, select "Off" for CH 3 to CH 8.
keys, the ENTER key, and the QUIT
and keys to select
keys to move the cursor.
3. Press the ENTER key to confirm
your selection.