Table of Contents
Advertisement
4
. MENU
Press the MENU key to open a setup menu. Each time this key is pressed, the setup screen
tabs change in the sequence shown below.
AMP
DATA
TRIG
OPT
OTHR
5
. QUIT (LOCAL)
Press the QUIT key to cancel the settings and return them to their default status. If the
device is in the Remote (Key Lock) status, namely the external operating status via the
interface, press this key to return the device to the normal operating status (Local).
6
.
keys (DIRECTION KEYS)
These keys are used to select menu setup items, to make span settings in the digital display
area, to move the cursors during a data replay operation, and so forth.
7
. ENTER
Press the ENTER key to enter the settings made in the setup menus, and to confirm your
settings.
8
.
These keys are used to move the cursor at high speed during a data replay operation, and to
change the operation mode in the file settings box. Hold down both keys simultaneously for
at least two seconds to enable key lock status. To cancel key lock status, press them again
for at least two seconds.
The key lock status can be confirmed by the status of the key lock lamp on the monitor.
6
lAMP Settings
Used to make the input, range, filter and other settings.
lData Capture Settings
Used to make settings such as the sampling interval, data
capture destination, and calculations during data capture.
lTrigger Settings
Used to specify data capture start and stop conditions, and
alarm conditions.
lOptions Settings
Used to set USB ID numbers and IP addresses, and to change
from one user to another.
lOther Settings
Used to make settings such as the screen brightness,
background color, and language.
keys (KEY LOCK)
Settings are
complete !
Advertisement
Table of Contents
