Projector Power Modes - Christie CP2320-RGB Installation And Setup Manual

4. Tighten the mounting arm until it fits tightly on the ball joint.
5. Connect the touch panel harness to the touch panel:
a) Connect one end of the USB cable to the USB port on the rear of the touch panel.
b) Connect one end of the touch panel power cable to the DC IN 12V port on the rear of the
touch panel.
c) Connect one end of the VGA connector to the VGA port on the rear of the touch panel.
6. Connect the touch panel harness to the projector:
a) Connect the other end of the USB cable to a USB port on the projector communications
panel.
b) Connect the other end of the touch panel power cable to the Screen Power port on the
projector communications panel.
c) Connect the other end of the VGA connector to the VGA Out port on the projector
communications panel.
7. To turn the touch panel on, press the power button on the top of the panel.
If the projector is not connected to AC power with breakers in the ON position, you cannot turn
the touch panel on.

Projector power modes

The CP2320-RGB projectors track laser operation hours for the laser optical sub-system (LOS).
The projector operates with the following power modes:
CP2320-RGB Installation and Setup Guide
020-102773-02 Rev. 1 (05-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installing and setting up
24