Installing The Lens - Christie CP2320-RGB Installation And Setup Manual

9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off and unplug the projector.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. On the front of the projector, move the lens clamp to the open position.
2. Position the lens so the lens retaining ring mounts align with the lens mount.
3. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
4. Insert the lens straight into the lens mount opening without turning.
Magnets inside the lens mount help position the lens.
5. Insert and tighten the two lens mount hex screws shipped separately with the projector.
6. Lock the lens assembly in place by rotating the lens clamp downward.
CP2320-RGB Installation and Setup Guide
020-102773-02 Rev. 1 (05-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installing and setting up
22