Sk-91460-Main With Sk-91460-91F467D-208Pfv; Connection To Sk-91460-Main - Fujitsu MB91460 Series Application Note

Serial Asynchronous Flash Programming
Chapter 6 SK-91460-MAIN with SK-91460-91F467D-208PFV

6 SK-91460-MAIN with SK-91460-91F467D-208PFV

This chapter describes the needed settings for programming the MB91F465D or
MB91F467D on the starterkit SK-91460-MAIN with adapter board SK-91460-91F467D-
208PFV.
The SK-91460-MAIN is a multifunctional evaluation board that has to be used together with
the emulator system or a separated microcontroller board for the Fujitsu 32-bit
microcontroller of MB91460 Series.
The SK-91460-91F467D-208PFV was build as an adapter board that can be used together
with the SK-91460-MAIN. It is also possible to use the SK-91460-91F467D-208PFV as a
stand-alone system with some limitations. The board allows the designer immediately to
start with the software development before his own final target system is available.
The SK-91460-91F467D-208PFV supports the MB91F465D and MB91F467D in the
QFP208 packages.
To program the flash memory of the microcontroller there are two ways in this combination.
You can use the SUB-D9 connector on the main board or on the adapter board. The second
method can also be used if the adapter board is used as standalone system.

6.1 Connection to SK-91460-MAIN

Figure 34: Connection to main board
For flash programming, the default setting of UART assignment can be used. With this
configuration, UART4 is connected to connector 'UART A'. You can also use one of the
other UART connectors if you change the assignment of UART and connectors.
MCU-AN-300012-E-V13 - 36 - © Fujitsu Microelectronics Europe GmbH