Sk-91464A-100Pmc - Fujitsu MB91460 Series Application Note

7 SK-91464A-100PMC

This chapter describes the needed settings for programming the MB91F464A on the
starterkit SK-91464A-100PMC.
The SK-91464A-100PMC is a multifunctional evaluation board for the Fujitsu 32bit flash
microcontroller MB91F464A in LQFP100 package. It is used stand-alone for software
development and testing.
For serial asynchronous programming SUB-D9 connector X5/UART "B" which is connected
to UART4 has to be used. Following jumper setting is needed:
Jumper
JP6 (UART"B"RxD)
JP8 (UART"B"TxD)
Table 16: Jumper setting on starterkit SK-91464A-100PMC
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 7 SK-91464A-100PMC
Figure 39: Connection to starterkit SK-91464A-100PMC
Setting
Closed SIN4 of the MCU is connected to UART"B"
Closed SOT4 of the MCU is connected to UART"B"
Description
- 41 - MCU-AN-300012-E-V13