Sk-91F467D-208Pfv (-Gpio) / Sk-91F467-Flexray - Fujitsu MB91460 Series Application Note

Chapter 5 SK-91F467D-208PFV (-GPIO) / SK-91F467-Flexray

5 SK-91F467D-208PFV (-GPIO) / SK-91F467-Flexray

This chapter describes the needed settings for programming the MB91F465D or
MB91F467D on the starterkit SK-91F467D-208PFV (or SK-91F467D-208PFV-GPIO, SK-
91F467D-Flexray)
The starterkit SK-91F467D-208PFV is a multifunctional development board for the FUJITSU
32bit flash microcontroller MB91F465D/MB91F467D in QFP208 package. It can be used
stand-alone for software development and testing or together with monitor debugger
software.
For serial asynchronous programming SUB-D9 connector X4 which is connected to UART4
has to be used. Following jumper setting is needed:
Jumper
JP60
JP65
JP69
Table 10: Jumper setting on starterkit SK-91F467D-208PFV
MCU-AN-300012-E-V13
Serial Asynchronous Flash Programming
Figure 32: Connection to starterkit SK-91F467D-208PFV
Setting Description
1-2 closed MCU SIN4 connected to RS-232 transceiver
1-2 closed MCU SOT4 connected to RS-232 transceiver
1-2 closed X4 pin2 is connected to RS-232 transceiver
- 34 - © Fujitsu Microelectronics Europe GmbH