Fujitsu MB91460 Series Application Note page 18

Select the device type, e.g. "MB91F467D", reset the microcontroller and press "Connect"
button. You can also use the DTR or RTS lines for resetting the MCU. Refer to chapter 3.1
for needed settings.
If connection is successful the functions on sheet "BootROM_Functions" become enabled.
To program embedded flash memory execute the functions "Write File", "Write Byte" and
"Call" with the default settings.
Function
Write File
Write Byte
Call
Read
Checksum
If you have performed the above mentioned steps and the appropriate bin-file (e.g.
"brl467d.bin" for the MB91F467D) is successfully loaded to RAM and started, go to sheet
"Flash_Functions".
MCU-AN-300012-E-V13
Serial Asynchronous Flash Programming
Chapter 2 FME-FR Programmer
Description
Dumps a binary file into the internal RAM beginning at the
specified address. The transmission will be verified by a
checksum.
Writes one single byte to the given location (RAM).
Calls the program or function at the given address. If there is a
"RET"-statement at the end, the operation will continue (return
value is displayed).
Reads out a number of bytes from a given address and creates
a binary file.
Displays the checksum from the last operation.
Table 3: BootROM Functions of FME-FR Programmer
Figure 10: Flash_Functions of FME-FR Programmer
- 16 - © Fujitsu Microelectronics Europe GmbH