Connect the adapter to the Textool
adapter to the starterkit using flat cable. Start the GALEP32 programmer software and use
'Load' command to load a bin or hex file. Select tab 'Devices' and browse to the correct
device, e.g. MCU
programming. In the information window below the correct programming adapter is listed.
Use 'Select Device!' button to accept current selection.
Use the functions now enabled on the bottom of the window to select action:
•
Program: write loaded mhx/bin-file to MCU
•
Verify: compare loaded file to Flash contents
•
Blank: do a blank check
•
Read: read-out Flash content
•
Erase: perform a chip erase
After selecting a operation, tab 'Action' is automatically activated. Press 'Start' button to start
operation.
For further information on available settings in software and jumper settings on starterkits
have a look at 'Options"
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 4 GALEP-Programmer
Figure 21: Serial Synchronous Programming
TM
–socket (take care pin 1 marking) and connect the
Fujitsu
MB91F467D. Choose SYNC for serial synchronous
'MB91F467D Options" (or other MCU type) and 'Device Help'.
- 25 -
MCU-AN-300012-E-V13