Fujitsu MB91460 Series Application Note page 37

Chapter 5 SK-91F467D-208PFV (-GPIO) / SK-91F467-Flexray
If your programming software needs connection of RTS and CTS or if it generates reset
signal on RTS or DTR line, refer to the following jumper list:
Jumper
JP58
JP64
JP57
JP29
Table 11: Jumper settings for reset signal on starterkit SK-91F467D-208PFV
JP29
Figure 33: Jumper setting on starterkit SK-91F467D-208PFV
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Setting Description
closed RTS and CTS is shortcut at connector X4
open RTS and CTS is not shortcut at connector X4
1-2 closed DTR can be used for system reset
2-3 closed RTS can be used for system reset
3-4 closed Reset will be done via UART4
1-2 closed No polarity inversion for the DTR/RTS signal
2-3 closed Polarity inversion for the DTR/RTS signal
- 35 -
JP58
X4
JP60 JP64
JP57
JP65 JP69
MCU-AN-300012-E-V13