Configuring Ptz Scans - Honeywell Performance HDZP252DI User Manual

82 | Performance Series IR 1080p IP PTZ Camera User Guide
4.
5.
6.
Running a Tour
1.
2.
Stopping a Running Tour
Use the PTZ controls to move the camera in any direction, or click the Stop button located next
to the Start button to stop the tour.
Deleting a Programmed Tour
1.
2.

Configuring PTZ Scans

You can program up to five scan paths. A scan is a short tour that runs on a horizontal line, back
and forth between two points that you program.
Programming a Scan Path
1.
2.
3.
www.honeywell.com/security
For every preset in the tour, double-click on the Preset name to bring up a drop-down list
of all programmed preset positions. Select the preset position that is needed for each
point in the tour.
The default Duration for each preset point is 10 seconds. To change the duration for a
preset, double-click the Duration for that preset and enter a new duration, in seconds, in
the field that appears.
Click Save under the Preset table to save all of the changes to the tour.

Navigate to Setup PTZ
In the Tour table, select the tour that you want to run and click Start.
Note You can also run a tour on the Live View page of the PTZ web client interface. See
PTZ Functions: Tour on page 26

Navigate to Setup PTZ
Click the Delete icon (

Navigate to Setup PTZ
In the Scan No. drop-down list, select the number of the scan that you want to program
(from 1 to 5).
Select the speed of the scan from the Speed bar, from 1 (slow) to 8 (fast).
 
Function Tour (see
for more information.
 
Function Tour (see
) for the tour you want to delete.
 
Function Scan (see
Figure 6-2).
Figure 6-2).
Figure 6-3).