Configuring Events and Alarms | 93
Configuring the Working Period
Configure the arm/disarm schedule. Click Setup to open the Working Period page. See
Recording Schedule and Snapshot Schedule on page 64
for more information.
You can configure up to six periods per day. Draw a circle in the table to enable the
corresponding time period.
Select a date. If you do not select a date, the current setup will be applied to today only. You
can select All to apply the working period to the whole week.
Click Save to save the changes. The system goes back to the Motion Detection interface. Click
Save to exit.
Figure 7-2
Configuring the Working Period
Configuring the Motion Detection Area
Configure the motion detection region, its sensitivity, and area. The default settings covers the
entire area. You must click Save to enable any changes to these settings.
800-22757 - A - 02/2017