Configuring A Smart Plan - Honeywell Performance HDZP252DI User Manual

Parameter
Working Period
Anti-Dither
Record
Record Delay
Send Email
PTZ
Snapshot

Configuring a Smart Plan

Smart Plan is a switch that enables the camera to use analytic features, such as face detection.
To enable a Smart Plan:
1.
Table 7-4 Audio Detection Configurations (cont'd)
Function
The audio detection is activated during the specified period. See
Configuring the Working Period on page
Click Setup. You can configure up to six periods per day. Draw a circle
in the table to enable the corresponding time period. Select a date. If
you do not select a date, the current setup will be applied to today only.
You can select All to apply the working period to the whole week.
Click Save to save the changes. The system goes back to the Audio
Detection interface. Click Save to exit.
The system logs and records only one event during the anti-dither
period. Choose an anti-dither period from 0 to 100 seconds.
When Record is enabled, audio detection will trigger a recording.
The system will wait for the specified time before it ends recording.
Select from 10 to 300 seconds.
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see
Select the PTZ check box to program the camera to perform a PTZ
action, from Preset, Tour, or Pattern when the audio event is active.
Select the action from the drop-down list and then the number of the
Preset, Tour, or Pattern to perform from the second drop-down list.
Check to enable the system to save snapshot files (still images) while
the audio detection event is activated. See
information about configuring where snapshots are saved.

Navigate to Setup Event
Figure 7-6 Smart Plan Configuration Interface
Configuring Events and Alarms | 97
SMTP (Email) on page

Smart Plan (see Figure
93.
54).
Path on page 62 for
7-6).
800-22757 - A - 02/2017