Configuring Video Tampering - Honeywell Performance HDZP252DI User Manual

1080 p ptz ip camera
Hide thumbs Also See for Performance HDZP252DI:
Table of Contents

Advertisement

Configuring Video Tampering

Parameter
Enable
Working Period
Record
Record Delay
Send Email
PTZ
Snapshot
Figure 7-4
Tampering Configuration Interface
Table 7-3
Tampering Configurations
Function
Check to enable the Video Tamper function.
The video masking feature is activated during the specified period. See
Configuring the Working Period on page
You can configure up to six periods per day. Draw a circle in the table
to enable the corresponding time period.
Select a date. If you do not select a date, the current setup will be
applied to today only. You can select All to apply the working period to
the whole week.
Click Save to save the changes. The system goes back to the Video
Tamper interface. Click Save to exit.
When Record is enabled, video tampering will trigger a recording.
The system will wait for the specified time before it ends recording.
Select from 10 to 300 seconds.
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see
Select the PTZ check box to program the camera to perform a PTZ
action, from Preset, Tour, or Pattern when the tampering event is active.
Select the action from the drop-down list and then the number of the
Preset, Tour, or Pattern to perform from the second drop-down list.
Check to enable the system to save tampering snapshot files (still
images) while the video tampering event is activated. See
65
for information about configuring where snapshots are saved.
Configuring Events and Alarms | 95
93.
SMTP (Email) on page
59).
800-22757 - A - 02/2017
Path on page

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Performance series

Table of Contents