Configuring Power Up Actions - Honeywell Performance HDZP252DI User Manual

2.
3.
4.
5.

Configuring Power Up Actions

Power Up actions can be configured for the PTZ to perform a programmed action when the
camera is powered up.
1.
2.
3.
4.
Check the Enable check box to enable the Idle Motion function.
In the Idle Time field, enter the amount of time to pass before the Idle Motion action will
occur, from 1 to 60 minutes.
Select the Idle Motion action to perform after the set time has passed, from Preset, Tour,
Scan and Pattern. After the action type is selected, use the drop-down list to select the
Preset, Tour, Scan or Pattern number to perform after the Idle Time has passed.
Click Save to save your settings.
Note You must have a Preset, Tour, Scan or Pattern programmed before you can set it
up as an Idle Motion action.
Figure 6-8 PowerUp Configuration Interface

Navigate to Setup PTZ
Check the Enable check box to enable the Power Up function.
Select the PowerUp action to perform after PTZ is powered up, from Preset, Tour, Scan,
Pattern and Auto. After the action type is selected, use the drop-down list to select the
Preset, Tour, Scan or Pattern number to perform when the PTZ powers up. If Auto is
selected, the PTZ will perform an automatic rotation before coming to a stop.
Click Save to save your settings.
 
Function PowerUp (see
PTZ Functions | 87
Figure 6-8).
800-22757 - A - 02/2017