Table of Contents
Advertisement
Appendix B:Certifications
F C C P a r t 1 5 C l a s s B
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Radio Frequency Interface (RFI) (FCC 15.105)
Labeling Requirements (FCC 15.19)
T
he Digi Connect Wi-Wave products comply with the standards cited in this
section.
The Digi Connect Wi-Wave embedded module has been tested and found to comply
with the limits for Class B digital devices pursuant to Part 15 Subpart B, of the FCC
rules. These limits are designed to provide reasonable protection against harmful
interference in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this
39
Advertisement
Table of Contents
