Appendix B Certifications; Fcc Part 15 Class B - Digi Connect ME Hardware Reference Manual

FCC Part 15 Class B

Radio Frequency Interference (RFI)(FCC 15.105)
Labeling Requirements (FCC 15.19)
Downloaded from Elcodis.com electronic components distributor
Certifications
A P P E N D I X
These products comply with the following standards.
The Digi Connect ME and Digi Connect Wi-ME embedded modules have been tested and
found to comply with the limits for Class B digital devices pursuant to Part 15 Subpart B,
of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.

 Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
If the FCC ID is not visible when installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed
B
5 6
      