Control; Dmx512-A; User Interface; Display - ETC Releve Spot User's Operation Manual

Hide thumbs Also See for Releve Spot:

Table of Contents

Control

The Relevé Spot is supplied with a 5-pin XLR input connector

and a 5-pin XLR pass through connector supporting DMX.

Compliant with:

•

DMX512-A (ANSI E1.11-2008 (R2013)

Note:

the last fixture in the DMX line with a 120 Ohm resistor or use a 5-pin male XLR DMX

terminator plug in the last luminaire's DMX Thru receptacle. A 5-pin XLR DMX

terminator is an accessory option available from ETC (order part number SGE1507).

ETC recommends using Belden 9729 (or equivalent) cable for a reliable DMX control system.

Note:

equivalent to the specified Belden 9729.

The Relevé Spot user interface (UI) consists of a display and button controls for local

configuration, and a USB (type A) port for firmware update. Use the display and button controls

to configure the luminaire for your specific application and installation needs.

The LCD is a graphic backlit display that automatically adjusts its orientation 180 degrees

according to its installed orientation (floor- or truss-mounted). While viewing the status screen,

pressing and holding the Enter o button for three seconds manually flips the display orientation

180 degrees from its current state. Button controls reorient to match the orientation of the

display. Display orientation may also be adjusted from the Options menu (see

DMX on the Relevé Spot luminaire is not self-terminating. You must terminate

Do not use microphone cable or other cable with characteristics that are non-

page 31

Relevé Spot User Operations Manual

Table of Contents