Rockwall Assembly - KidKraft COZY ESCAPE PLAYHOUSE F29045 Installation And Operating Instructions Manual

Step 19: Rockwall Assembly
A: Lay 2 (9484) Rails down, side by side with angled edges facing down. (Fig. 19.1)
B: Place (9522) Board Rock on the top of each (9484) Rail as shown in fig. 19.1. Do not attach. This board is to be
used as a guide only and will be attached in a later step. Make sure (9522) Board Rock is flush to the outside and top
edges of each (9484).
C: Taking note of the hole orientation, place 1 (9485) Board Rock at the bottom of the (9484) Rails, making sure that
it is flush to the edges and the bottom. Attach using 4 (S20) #8 x 1-3/8" Wood Screws. (Fig. 19.1)
D: In between the top and bottom board, evenly space the remaining (9485) Board Rocks, making sure that the
pre-drilled rock holes are at opposite ends on each board. This will prevent rocks from forming a straight line. Attach
using 4 (S20) #8 x 1-3/8" Wood Screws per board. (Fig. 19.1)
E: Alternating colors and shapes, place 1 rock on each (9485) Board Rock and attach using 1 (PB2) 1/4 x 1-1/4" Pan
Bolt (with lock washer, flat washer and barrel nut) and 1 (S10) #8 x 1" Pan Screw per rock. The Screw must be in the
hole directly under the Pan Bolt, this will stop the rock from spinning. (Fig. 19.2 & 19.3 &19.4.&19.5).
Fig. 19.1
9522
x 4 per
S20
Board
Fig. 19.3
S10
Wood Parts
1 x Board Rock 5/8 x 4-1/2 x 19-11/16 "
9522
7 x Board Rock 5/8 x 4-1/2 x 19-11/16"
9485
2 x Rail 1-1/4 x 2-1/2 x 50-45/64"
9484
9485 x 7
PB2
1/4" Lock
Washer
3/16" Flat
Washer
1/4"
Barrel Nut
Hardware
7 x 1/4 x 1-1/4 Pan Bolt
PB2
(1/4" lock washer, 3/16" flat washer & 1/4" barrel nut)
7 x #8 x 1" Pan Screw
S10
28 x #8 x 1-3/8" Wood Screw
S20
Fig. 19.5
Note hole orientation
X
9484
Rock B x 4
49
Fig. 19.2
updated image for fig.12.7, pg 49 of version 6
PB2
1/4" Lock
Washer
3/16" Flat
S10
Washer
1/4"
Barrel Nut
Fig. 19.4
Rock A x 3
Other Parts
3 x Rock A
4 x Rock B