Click
Torque Tool A Clicks When the Captive Screws are Correctly Torqued
FIGURE 16
13. Return torque tool A to its storage location in the workstation.
14. If necessary, reinstall the filler panel for the shroud.
Caution – To ensure proper workstation cooling, any unused CPU slot must contain
a filler panel for the shroud (see
15. Detach the antistatic wrist strap, replace the access panel, plug in the power cord,
and power on the workstation.
16. Proceed to "Finishing the Installation" on page 28.
).
FIGURE 7
Sun Blade 1000 UltraSPARC III CPU Module Installation Instructions
Torque tool A
Captive screw(2)
27