Finishing Component Installation - Sun Microsystems Blade 150 Installation Manual

Correct DIMM Insertion
FIGURE 5
7. Repeat Steps 3 through 6 until you are finished installing the
additional DIMMs.
8. Complete the next section, "Finishing Component Installation"
on page 10.

Finishing Component Installation

1. Reconnect the system power cord (
2. Remove your antistatic wrist strap from the chassis.
3. Replace the system cover onto the system chassis.
4. Align the cover tabs with the slots on the system chassis, then
slide the cover toward the front of the system until the front
cover tabs lock.
10
Alignment
notch
FIGURE 2
).