Removing Atomizer Head - USC LP2000 Operator's Manual

3. Slide the atomizer straight back and drop down to access the atomizer head
and bearing (below). To completely remove the housing from the treater, unplug
the motor from the control panel and disconnect the treatment lines.
Below are instructions and pictures that illustrate how the atomizer head is removed
and where the bearing is located.
1. Remove the small nipple that leads down into the atomizer head. The nipple is
threaded only into the 90 degree elbow fitting.
Small nipple
LP2000 with Seed Wheel

Removing Atomizer Head

USC,
LLC
90 degree elbow
Page 57