Bottom Of Control Panel - USC LP2000 Operator's Manual

LP2000 with Seed Wheel
7. Liquid Adj. Pump #2:
This dial allows the operator to adjust the speed of pump
#2. The setting should be chosen in relation to the application rate for the treatment
being applied to the seed.
8. Inlet Conveyor Switch:
This switch controls the
inlet conveyor in conjunction with a timer relay. When
the switch is turned on, the conveyor will run until
seed covers the proximity switch mounted near the
top of the supply hopper, at which time the conveyor
will turn off automatically. The inlet conveyor will
remain off until seed has dropped below the proximity
switch. A timer relay (right) will turn the conveyor
back on after a pre-determined time. The timer relay
located inside the control panel is set to Mode "A" and
has an adjustable knob with settings from 0-6. Each
number represents the number of seconds from the
time the proximity switch is uncovered to when the
conveyor will turn back on. The time delay prevents
the conveyor from turning on and off too quickly.
9. Drum:
This switch allows the operator to turn the drum on or off.
10. Atomizer:
This switch allows the operator to turn the rotary driven atomizer on
or off for primary distribution of product on the seed. This switch must be turned on
before the seed treating process begins and before the pump(s) will operate in
"Auto".
11. Mix Tank:
This switch allows the operator to turn the chemical mixer/agitator
on or off to allow for a perfectly mixed application of the seed treatment.
Page 30 USC,
LLC