USC LP2000 Operator's Manual page 62

1. Make certain the inside of the tank is completely drained of chemical residue and
thoroughly flush the inside of the tank with clean water.
2. Remove and clean the filter.
3. Pump clean water through all areas of the plumbing including the mix tank,
calibration tube, and valves.
4. Open all drain points, valves, and filter to let as much of the liquid drain as
possible.
5. If the seed treater will be exposed to possible
freezing temperatures, the final flush of the
system should be made with an non freezable
liquid. Or use compressed air to blow the lines
out from any moisture.
6. Release pump head (right) and remove tubing to
prevent any unnecessary wear.
1. Store the machine inside a protective building to keep it from being exposed to
the weather.
2. Disconnect power to the machine.
Page 62
LP2000 with Seed Wheel
LIQUID SYSTEM
FINAL
USC,
LLC