Controls Explained; Hand/Off/Auto Switch (For Pump #1 & #2); Pump #1/2 Direction; Liquid Adj. Pump #1 - USC LP2000 Operator's Manual

Seed treater with seed wheel

Hide thumbs

Table Of Contents

Table of Contents

1. Pump #1 Voltmeter:

is increased or decreased, this number will also increase or decrease.

2. Hand/Off/Auto Switch (for Pump #1 & #2):

pump #2, and any device connected to the auxiliary port. This switch must be

activated before either pump will operate in forward or reverse.

When this switch is placed in "Hand", the pump(s) will run only when you have



turned the pump(s) switch to forward or reverse, and the speed has been

adjusted.

When the switch is placed in "AUTO", the pump(s)



will only run when the the proximity switches located

in the seed wheel are covered and the atomizer is

running. The proximity switches determine when

seed is present in the seed wheel. When the

proximity switches do not detect seed, a timer relay

located inside the control panel will automatically

shut off the pump(s) a pre-determined amount of

time after the hopper has emptied. The timer relay

(right) located in the control panel is set to Mode "D"

and has an adjustable knob with settings from 0-6.

Each number represents the number of seconds

from the time the hopper empties until the pumps

will shut off. The time delay allows all seed that

passes through the atomizer to have equal coverage.

3. Pump #1 Direction:

direction between forward and reverse. It has a safety feature that will not allow the

operator to switch from forward to reverse or vice-versa without momentarily

stopping and releasing the switch in the center position.

4. Liquid Adj. Pump #1:

#1. The setting should be chosen in relation to the application rate for the treatment

being applied to the seed.

5. Pump #2 Voltmeter:

is increased or decreased, this number will also increase or decrease.

6. Pump #2 Direction:

direction between forward and reverse. It has a safety feature that will not allow the

operator to switch from forward to reverse or vice-versa without momentarily

stopping and releasing the switch in the center position.

LP2000 with Seed Wheel