USC LP2000 Operator's Manual page 20

The purpose of the seed wheel is to simplify calibration and make seed flow
calibration more accurate. The seed wheel saves time when switching to different
seed sizes and seed types, and can be mounted to most LP800 and LP2000
models.
(1) Openings
to Wheel
(3) Proximity
Switch
1. Openings to Wheel:
pockets.
2. Variable Speed Motor:
your desired seed flow.
3. Proximity Switch:
switch on the seed treater is in the Automatic position. When seed is covering this
sensor and the pump switch is in Auto, the pump(s) will run. When seed is no
longer covering this sensor, the pump(s) will shut off.
Page 20
LP2000 with Seed Wheel
(4) Seed
Wheel
This is where the seed is dispensed into the wheel
Drives the wheel and the speed can be adjusted to fit
Controls when the pump(s) turn on and off when the pump
USC,
LLC
(2) Variable
Speed Motor
(6) Brush
(5) Opening
to Atomizer