USC LP2000 Operator's Manual page 37

1. Select the type of seed to be treated. EXAMPLE: SOYBEANS
2. Enter the total number of pounds to be treated. EXAMPLE: 2500
3. Enter in the weight of seed in the cup (follow the steps on page 34).
EXAMPLE: 3.58
4. Enter in the desired seed flow rate. This is a number that is determined by the
operator. Minimum seed flow rate is approximately 300 lbs per minute. The
maximum seed flow rate is 800 lbs per minute for an LP800 and 1900 lbs per
minute for an LP2000. EXAMPLE: 700
5. Enter in the ounces to be applied per hundred pounds(cwt). EXAMPLE: 5.00
6. Set the Seed Wheel RPM using the number in the orange colored cell found in the
same row as the seed type to be treated. EXAMPLE: 4.75
7. After the Seed Wheel RPM has been set, the first batch of seed can be treated.
Double check the accuracy by timing the first batch of seed as it passes through the
atomizer of the seed treater.
LP2000 with Seed Wheel
USC,
LLC
Page 37