Removing Atomizer Housing - USC LP2000 Operator's Manual

Below are instructions and pictures that illustrate how the atomizer is removed and
where the bearing is located.
1. Remove the two bolts that secure the control panel in place, and swing out the
control panel. The inoculant tank can also be swung open at this time.
Control
Panel
2. Release the red-handled clamp and remove the small shipping bolt. Also
loosen the two 5/16" bolts, located towards the front of the atomizer. This holds
the top atomizer flange tight against the adjustable seed gate flange (below
right).
Red-Handled Clamp
Page 56
LP2000 with Seed Wheel

Removing Atomizer Housing

USC,
LLC
Inoculant
Tank