Controls And Indications - Honeywell GENT Nano panel-based Commissioning Instructions

Controls and indications

Nano Fire Alarm System
Gent by Honeywell
Menu
Cancel
Buzzer
Reset
Disablement
Test
System Fault Power Fault
Zone 2
Zone 1
Zone 5 Zone 6
Zone 10
Zone 9
Zone 14
Zone 13
FAULT POWER
4188-949 issue 3_05/10_Nano Comms inst.
16:15 Mon 15/02/10
Sound Silence
Alarms Alarms
Delay Verify
Sounder
Sounder Fault
Disablement
Zone 4
Zone 3
Zone 8
Zone 7
Zone 12
Zone 11
Zone 16
Zone 15
FIRE
Indications
POWER
When illuminated it indicates that power supply to the panel is present.
[green LED]
FIRE
When illuminated it indicates that a FIRE has been detected
in the protected premises.
[red LED]
ZONE n
When illuminated it indicates that a FIRE has been detected in the
respective zone(s).
[red LEDs]
FAULT
When illuminated it indicates that a FAULT has been detected
in the fire detection and alarm system.
[amber LED]
When illuminated it indicates that a part of the system has been
Disablement
disabled.
[amber LED]
When illuminated it indicates one or more zones are in Test mode.
Test
[amber LED]
Power Fault When illuminated it indicates the battery or mains supply to the
panel has failed.
[amber LED]
When illuminated it indicates that one or more delays are setup
Delay
on the panel.
[amber LED]
When illuminated always with the FAULT LED, it indicates that
Sounder Fault
there is a sounder fault .
[amber LED]
When illuminated it indicates the verification delay is active.
Verify
Verification delay is activated by selecting the Verify option,
which will further delay the operation of alarm sounders in the system.
[amber LED]
When illuminated it indicates that a fault has occurred with
System Fault
the system processor.
[amber LED]
It is important to investigate this fault because the fire alarm system
may not be able to detect fires.
Sounder
When illuminated always with the DISABLEMENT LED, it indicates
Disablement
that there is sounder disablement.
[amber LED]
Nano panel based system
9