How To Restore 'Config', 'Labels' Or 'Logo' From A Sd Card; How To Use A Sd Card To Log 'Historic Events' For Diagnostics - Honeywell GENT Nano panel-based Commissioning Instructions

How to restore 'Config', 'Labels' or 'Logo' from a SD card

A previously saved system configuration data, labels and proprietary Logo file on a SD card can be restored to the panel. You will need to be at access level 4 to load configuration stored on a SD card.
Menu
Engineering Maintenance >
Select
Ensure the SD card is fitted into the Main Control Board.
After configuration is restored you will need to back-up the data to
memory. Ensure the write protect link P9 on the MCB is configured in
the ENABLED position to allow back-up of data.

How to use a SD card to log 'Historic Events' for diagnostics

Up to 64 million historic events can be stored on to a 1G byte regular SD card when it is left inserted in the SD card slot on MCB. The SD card must have a folder named nanologs to enable the
panel to create and store historic log to a text file in the folder. The text file on the SD card can be opened and viewed via a card reader connected to a PC. The historic log of the panel is unaffected by
the introduction of SD card to keep a large store of historic events.
4188-949 issue 3_05/10_Nano Comms inst.
SD Card Select Select
Select Select
Logo Select
All Select
Restore Select Labels Select
DO NOT remove the SD card
while the RED LED is flashing.
RED LED
Nano panel based system
16:15 Tue 16/02/10
This will load the logo
data from the SD card!!
Are you sure?
Yes No
16:15 Tue 16/02/10
This will load the configuration
data from your SD card!!
Are you sure?
Yes No
16:15 Tue 16/02/10
This will load the labels
data from your SD card!!
Are you sure?
Yes No
Main Control Board
SD card
Yes
Yes
Yes
69