External Wiring - Honeywell GENT Nano panel-based Commissioning Instructions

External Wiring

The following procedures assume the Nano panel is installed.
j
¨
Remove the Screw cover from the Outer cover to reveal the fixing screws
k
¨
Using the allen key open the two fixing screws
¨
Open out the bottom edge of the Outer cover and lift it up and out
¨
Depending on the installation, the cables may be connected to respective terminals or left unconnected. If the cables are to be connected then straighten out the cable tails
then one-by-one connect each cable to the respective terminals.
Master
Fire
alarms 2
LOOP 1
Relay
END 1
Cancel Sound Silence
Buzzer Alarms Alarms
Class Reset Master
LOOP 1
alarms 1
Change
END 2
Disablement Test Delay
Test
Sounder
System Fault Power Fault Sounder Fault
Disablement
Zone 4
Zone 1 Zone 2 Zone 3
Zone 8
Zone 5 Zone 6 Zone 7
Zone 12
Zone 9 Zone 10 Zone 11
Zone 16
Zone 13 Zone 14 Zone 15
FAULT POWER FIRE
Backbox
4188-949 issue 3_05/10_Nano Comms inst.
l
.
MAINS
SUPPLY
Outer Cover
Screw cover
Allen Key
Nano panel based system
m
and
11