Steering Wheel Angle Front And Rear Adjustment; Pedal Accelerator Operation; Pedal Brake Operation; Use Of Emergency Power Off Safety Switch - EKKO EK20R Manual

the lowest position, tighten the parking brake handle, press the safety switch,
and pull out the key. (Note that you cannot leave the truck without tightening the
hand brake lever).
8.2 The steering wheel Angle adjustment
According to the individual operating habits, steering wheel angle can be
adjusted . Adjustment method is as follows: Loosen the left hand of direction
column, adjust the steering wheel to the right position, then lock regulating
handle.
8.3 Accelerator pedal operation
Determine the vehicle forward or backward. Toggle joystick in place, right
foot will tread the foot pedal accelerator to make the forklift slowly forward or
backward. Continue down the pedal, the forklift 's speed to speed up.
Started never put foot accelerator jammed on to the end, in order to avoid
the vehicle out of control.
8.4 Brake pedal operation
When the moving forklift needs to stop, release the pedal accelerator,
move the right foot to the middle of the foot brake pedal, and the vehicle will
stop after braking
8.5The using of emergency power safety switch
If the forklift is out of control during driving, or if it is smoked or burnt
during use, please press the emergency switch on the forklift seat cover and the
power will be cut off. Find out the cause and clear the fault before you can open it.
The method of opening is as follows: the emergency power-off safety switch is
rotated in the direction indicated by the arrow above the button, and the opening
is completed.
28