Operating Specification; Sart ,Running And Parking - EKKO EK20R Manual

Before operating the forklift, please be familiar with the dashboard function
of each switch/button.
8.1 Start ,Run Parking
○
1 Insert the key into the key switch, turn to the right, and turn the
emergency power off safety switch in the direction indicated by the arrow above
the button. The control circuit opens.
○
2 The fork rises from the ground about 10 cm。
○
3 Begin to loosen parking system.
○
4 According to the requirements in the direction of the forward or
backward direction of switches
○
5 On the accelerating pedal slowly, until the required speed.
○
6 In the process of operation, forklift exception occurs fault, need to
quickly cut off power supply, please press the red emergency power switch.
○
7 When the forklift is turning, you should reduce the speed and, if
possible, try not to make sharp turns.。
○
8 Forklift truck carrying gradeability is 15%, so the uphill slope need to
understand the situation, when climbing the forklift must accelerator pedal
pressed down as far as possible, the maximum climbing force can be achieved
○
9 When the forklift is downhill, release the accelerator pedal, please
press the brake pedal at the same time to ensure safety.。
○
10 When the truck stops driving, the right foot leaves the accelerator pedal
and the forklift pedal is pressed until the truck stops completely. Put the fork to
8、Operating Specification
27