Ametek Surgex UPS-17202-53R User Manual page 24

_________________________________________________________________
Before connecting a battery cabinet to the UPS, the circuit breaker of the
battery pack must be switched to "OFF". After electrical connection with
the UPS is established, the breaker must be switched to "ON".
NOTE:
Each battery cabinet contains two battery connectors. The
first battery cabinet is connected to the UPS using the cable
supplied with the cabinet. Each additional extension battery cabinet
is connected by attaching its cable to the previous cabinet.
Refer to the figure on the next page.
If additional battery cabinets (up to 4) are to be used, they should be
connected prior to connecting the UPS to the input power. To connect
external battery cabinets, follow the steps below:
1. Set the circuit breaker to the "OFF" position.
2. Remove the battery connector cover from the UPS.
3. Remove the battery connector cover from the extended battery
cabinet.
4. If there are multiple extended batter cabinets, remove the addition-
al battery connector covers. If not, proceed to Step 5.
5. Connect the supplied battery cable to the extended battery cabinet.
6. Connect the other end of the battery cable to the UPS.
7. For multiple extended battery cabinets, connect the supplied bat-
tery cables as shown in the figure below.
8. Set the circuit breaker to the "ON" position.
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
CAUTION
User Manual
19