Bypass Mode Enable/Disable When The Ups Is Off; Programmable Outlets Enable/Disable (Item 07); Programmable Outlets Setting (Item 08) - Ametek Surgex UPS-17202-53R User Manual

_________________________________________________________________
4.2.4 Bypass Mode Enable /Disable when the UPS is off (Item 06)
Interface
4.2.5 Programmable Outlets Enable /Disable (Item 07)
Interface

4.2.6 Programmable Outlets Setting (Item 08)

Interface
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
Setting
ENA: Bypass mode is enabled when the UPS is turned off.
When the UPS is first plugged in, it will enter bypass
mode, or if the UPS is in on-line mode and then turned off,
it will enter bypass mode.
DIS: Bypass mode is disabled when the UPS is turned
off. When the UPS is first plugged in, it will enter
standby mode with no output, or if the UPS is in on-line
mode and then turned off , it will enter standby mode with
no output.
Setting
ENA: Programmable outlets are enabled. When the UPS
goes to Battery mode the programmable outlets will supply
power to the connected load for a duration equal to the
timer setting in section 4.0 or until the battery becomes
depleted, whiche ver occurs first.
DIS: Programmable outlets are disabled. When the UPS
goes to battery mode the programmable outlets will supply
power to the connected load until the battery becomes
depleted.
Setting
0-999: Backup time in minutes that programmable output
receptacles will operate in battery mode.
User Manual
24