Ups Operation; Ups Input Connection; Lcd Display In Bypass Mode - Ametek Surgex UPS-17202-53R User Manual

User Manual
_________________________________________________________________

5. UPS OPERATION

5.1 UPS Input Connection

Plug the input of the UPS into a two-pole, three-wire, grounded recepta-
cle. Avoid using extension cords.
Attention
This UPS is supplied with standard power cords and re-
ceptacles suitable for use in your area of operation. It may
be installed and operated by non-technical personnel.
If the mains voltage is within the acceptable range, and the bypass is en-
abled the UPS will enter bypass mode. "BYPASS" will be displayed in the
UPS status window on the LCD display. See Section 5.0 "LCD Display in
Bypass Mode".
If instead the bypass is disabled, the UPS will enter standby mode. In
this mode the UPS will not supply output power to the load. See Section
5.0 " LCD Display in Standby Mode".

5.1.1 LCD Display in Bypass Mode

Rack Display Tower Display
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com 26