_________________________________________________________________
4. SETTING UP UPS PARAMETERS
4.1 Factory Default Settings
The UPS is shipped with the following default factory settings. Refer to
the table below and also to the table "LCD Display Abbreviation Index".
PARAMETER
Output Voltage
Frequency Converter
Output Frequency
Bypass Mode
Programmable Outlets
Programmable Outlets Backup Time Setting
LCD Display Direction Setting
Acceptable Input Voltage Range Setting
Number of External Battery Cabinets
If the factory default settings are acceptable, proceed directly to Section
"UPS OPERATION". To change any of the default settings proceed
directly to Section 4.0 "Changing Default Settings".
4.2 Changing Default Settings
Plug the input of the UPS into a two-pole, three-wire, grounded recep-
tacle. Avoid using extension cords. If the mains voltage is within the
acceptable range, the UPS will enter bypass mode. "BYPASS" will be
displayed in the UPS status window on the LCD display.
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
User Manual
FACTORY DEFAULT SETTING
100 - 120 Volt
Models
120
DIS
60
ENA
DIS
2
RAC
85-135
0
200 - 240 Volt
Models
208
180-300
21