Battery Safety - Ametek Surgex UPS-17202-53R User Manual

_________________________________________________________________
•
If the equipment is moved from a cold environment to a warmer
operation location, condensation may occur. Before you switch on
the equipment it must be absolutely dry. An acclimatization pe-
riod of at least two hours is required.
•
Place all cords so that nobody can stand on or trip over them.
When connecting the device to the power supply, follow the
instructions in Section 3 "Installation".
•
Do not connect equipment that will overload the UPS or demand
DC-current.
•
When cleaning the unit, follow the instructions in Section 8
"Maintenance".
•
Emergency power off (EPO) is located on the rear of the unit (see
Section 2.7 "Rear Panel View"). When this connection is open, the
logic circuit will immediately shut down the UPS output.

1.4.4 Battery Safety

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE
INSTRUCTIONS
The batteries installed in the UPS and within the extended battery
cabinets contain electrolyte. Under normal conditions the containers are
dry. A damaged battery may leak electrolyte that can be dangerous
when in contact with the skin and cause irritation to the eyes. Should this
happen, wash the affected part with copious amounts of water and seek
immediate medical attention.
•
Voltage is always present on the battery terminals.
•
Even when discharged, a battery has the capacity to supply a high
short circuit current, which in addition to causing damage to the
battery itself and to associated cables, may expose the operator to
the risk of burns.
•
Batteries should not be kept in storage for periods exceeding 6
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
CAUTION
User Manual
5