AT&T UNIX Telephone Manager User Manual page 90

Creating Directory Entries
o If you want to create a new data profile, use
the Create command from the Filecabinet.
Creating a new data profile is described
under "Creating Data Profiles" in the Setting
Up the Software for Data Calls section of the
AT&T UNIX PC Terminal Emulation User's Guide.
o If you want to modify an existing profile,
see "Modifying Data Profiles" in the Setting
Up the Software for Data Calls section of the
AT&T UNIX PC Terminal Emulatjon User's Guide.
For complete information about data profiles, refer to
the AT&T UNIX PC Terminal Emulatjon User's Gujde.
Connection
The Connection field lets you specify which type of
connection you want to use. Note that the connection
you use must match the type of profile named in the
Data Profile Name field. Press the Mark key until you
see the type of connection you want to make.
The following list describes some possible connection
types:
o Modem for calls using the built-in modem.
o Serial Port n for calls using an RS-232 cable
(n represents the RS-232 port number 0
through 6) .
o STARLAN for calls to the STARLAN Network
communications network. (Note that STARLAN
Network software must be installed.)
o SNA 3270 and Bisync 3270 for IBM 3270
emulation calls. (Note that 3270 software
must be installed.)
Fields
8
and
9
These optional fields let you store additional
information for the entry. Each field holds up to
45
characters. Only the first 17 characters of the field
appear in the Call screen and Directory.
4-30