Placing Calls - AT&T UNIX Telephone Manager User Manual

Placing Calls
If your system has only one telephone line connected,
Telephone Manager switches the line automatically
between voice and data lines as you need. You can use
the LINE SELECT screen to switch the line manually.
Note that an impending voice call function, such as
camp-on or standby queueing, interrupts a data call.
If you have any of these PBX-type functions pending on
the line, cancel them before changing line 1 to a data
line and placing the data call.
In this example, only one telephone line is set up. It
is set up for voice calls:
llJlIIH • •
mlt_
Fri Hay 39, 12:48
Pili
If you want to make a data calIon this line, just
place the data call; Telephone Manager switches the
line to data automatically. You can use the LINE
SELECT key to switch the line manually.
Note
In a single line system, if you want to
receive electronic mail and other data
calls, the line must be a data line. If
you want to receive voice calls, be sure
you return the data line to a voice line
when a data call is complete. You
cannot receive voice calls while the
line is set as a data line.
Placing Calls
You can place a call in several different ways. Some
methods are used only for voice calls. Each method is
described below.
4-55